![]() ![]() Add soil sensors (I haven't done this yet – not supported by Open Sprinkler as of publish date).Integrate with weather reports (built in to OpenSprinkler).Add functionality to the irrigation system.Control the irrigation system from the web.Don’t lose any functionality from current Rainbird irrigation system.If you are looking for a first project, do this one. This is the perfect home automation project. This instructable simply documents my progress in Home Automation. OpenSprinkler doesn't need an instructable. It is an easy and low-cost solution to transform a Raspberry Pi into a capable sprinkler controller with 8 zones for lawn and garden watering. OpenSprinkler Pi (OSPi) is an open-source sprinkler / irrigation extension board for the Raspberry Pi. I updated it JUL2021 to use latest build and newer hardware. Sets/Shows the amount of time (hours) that rain has caused programs to be delayed.This instructable was published in 2015. When OFF, manually started stations will still work. The ON command will stop all stations immediately, including those waiting to run.Īllow programs to auto run. The time the station will open for when any stations are selected from the Selected will start that program for you.ĭisplay a list of stations that can be run when selected to the length of time set Shows the number of pulses the optional water flow sensor has reported.ĭisplays a list of the programs that are setup in your OpenSprinkler and when The water level isĬalculated based on the weather and influences the duration of the water programs. This channel shows the current water level in percent (0-250%). This channel is for the second sensor (if your hardware supports it). This channel indicates whether rain is detected by the device or not. NOTE: Some channels will only show up if the hardware has the required sensor and is setup correctly. ![]() The following channels are supported by the device thing. MapDB) in order to persist the value through restarts. When using the nextDuration channel, it is advised to setup persistence (e.g. This channel makes the station ignore the rain delay. Supported (which removes the station from the queue). The channel cannot be turned on, only turning it off is Indicates that the station is queued to be turned on. Value will default to 18 hours which is the maximum time The amount of time that will be used to keep the station This channel indicates whether the station is on or off. The following channels are supported by the station thing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |